Sadid Almashregh PVC flooring and PVC wall covering skilled Laboratory
Simultaneously with the establishment of the Sadid Almashregh factory, the polymer and UPVC laboratory of this company was also launched. This laboratory started its activity with the cooperation of our collection management and the use of the latest technology of this industry, modern and updated equipment, expert and experienced Human labor. Sadid Almashregh Laboratory intends to take another step towards achieving the company’s high goals by obtaining international certificates.
The experiment Related to UPVC profiles
Weld ability test
In this test, welded joints are evaluated. This device shows the fracture rate of the welded section in terms of Newton (N).
Notch device
At first, we create two V-shaped slits on the tested profile sample and the sample is prepared for the First, we create two V-shaped slits on the tested profile sample and the sample is prepared for the sharpie impact resistance test. Impact resistance test.
Thermal recovery test
Thermal return:
In this case, the sample is placed in a 100 degree temperature for one hour and then the amount of thermal return is measured.
Appearance changes after exposure to 150 degree temperature:
In this test, the profile sample is placed in a 150 degree temperature for 30 minutes, and then the change of the profile, such as layering or the appearance of blisters, etc., will check.
Color tolerance test
With using this device, the permitted color tolerance test is performed, and every production time, the color of the profile is adjusted according to the defined standards of Sadid Almashregh Company.
Density test
Test to determine mass per unit length
0.01 gram scale – this accurate scale is used to measure the mass of a unit of length.
0.0001 gram scale with density kit – this scale is used to measure density.
Resistance test
Impact resistance test caused by falling mass at low temperatures
In this test, a weight is dropped from a certain height to measure the strength of the profile against failure.
Incubator
This device is used to cool the sample down to 10 degrees below zero in order to use it in tests that require cooling the profile.
Sharpie impact resistance test
This device is used to determine the impact strength of two V-shaped slots.
Appearance changes test
Thermal recovery: In this case, the sample is placed in the 100 degree temperature for one hour and then the amount of thermal recovery will be measured.
Appearance changes after exposure to 150 degree temperature:
In this test, the profile sample is placed in the 150 degree temperature for 30 minutes, and then the change of the profile, such as layering or the appearance of blisters, etc., is checked.
Vicat softening point temperature test
This device is used to determine the softening point.